Please read the entire instruction manual to ensure you are familiar with each step before beginning.
Before you get started, check out the "How It Works" video on our website : theforeverkit.com/howitworks
Before you begin:
Prepare an area to perform the molding and casting process. A flat, hard, smooth surface that can be wiped down easily works best.
Items not included that you need:
Remove the contents inside The Forever Kit bucket and pour 8 cups of COLD water into the bucket.
Step B through E are time sensitive, so you will need to act fast.
Empty the MOLDING POWDER into the water.
Let it sit for
Slowly stir the powder for approximately 60 seconds with a mixing utensil or an electric mixer.
Dip your hands in the mixture to cover your hands.
IMMEDIATELY insert hands into the bucket.Remain as still as possible.
minutes for the
mixture to set
Gently tap your finger on the surface of the mixture to see if it’s hardened.
Remove hands one at a time.
Set aside 1 tbsp of CASTING POWDER , for touch ups.
Put on gloves.
Measure 2.5 Cups of COLD water and pour into a large mixing bowl.
Empty the CASTING POWDER into the mixing bowl.
Let it sit for
Slowly stir the powder for approximately 1-2 minutes, until it has a paint like consistency.
Pour Pour the casting mixture into the mold . Make sure the casting mixture reaches everywhere and the cavity is full. (Don’t fill up past the top of the cavity)
Tap and gently shake the bucket side to side until mixture begins to set.
Dispose of excess casting mix in the trash. (Not the sink)
Wait for the cast to
hardern for 5-6 hours. (don't let the
cast harden for more than 10 hours)
Turn the bucket upside down. Push and pull on the sides and allow the mold to slide out.
Carefully peel the mold away from the cast.
Use the supplied sculpting tool to remove the mold from any crevices.
Any space left by air bubbles can be filled with a small amount of casting powder.
Rinse the cast with clean water and set aside to cure.
Allow the cast to cure in a warm, dry environment for approximately 24 hours.
Let it cure for
Once dry, sand cast down.
We hope you enjoyed the forever kit!